CDMA2000 BTS Analyzer (Option K82) R&S FSL
1300.2519.12 4.344 E-11
Percent Marker
"Opens an edit dialog box to enter a probability value and to position marker 1. Thus, the power
which is exceeded with a given probability can be determined very easily. If marker 1 is
deactivated, it will be switched on automatically.
This softkey is only available for the CCDF measurement.
Remote: CALC:MARK:Y:PERC 0…100%
Softkeys of the marker–> menu (CDMA2000 BTS Analyzer mode)
The following table shows all softkeys available in the marker–> menu in CDMA2000 BTS Analyzer
mode. It is possible that your instrument configuration does not provide all softkeys. If a softkey is only
available with a special option, model or measurement mode, this information is delivered in the
corresponding softkey description.
The softkeys of the marker-> menu are not available for the Result Summary, Channel Table and
CCDF measurements.
Command
Select 1 2 3 4
Peak
Next Peak
Next Peak Mode < abs>
F-PICH
F-TDPICH
More
Select 1 2 3 4
Min
Next Min
Next Min Mode < abs>
Select 1 2 3 4
Selects the normal marker or the delta markers, activates the marker and opens an edit dialog
box to enter a value for the marker to be set to.
stands for delta marker 1.
Since the Channel Bitstream measurements supports only one marker, this softkey is not
available for that measurement.
Remote: CALC:MARK1 ON
Remote: CALC:MARK1:X <value>
Remote: CALC:MARK1:Y?
Peak
For details refer to the Peak softkey in the MKR-> menu of the base unit.
To Next Page
Loading...
