R&S FSL CDMA2000 BTS Analyzer (Option K82)
1300.2519.12 4.343 E-11
Softkeys of the marker menu (CDMA2000 BTS Analyzer mode)
The following table shows all softkeys available in the marker menu in CDMA2000 BTS Analyzer
mode. It is possible that your instrument configuration does not provide all softkeys. If a softkey is only
available with a special option, model or measurement mode, this information is delivered in the
corresponding softkey description.
T
he softkeys of the marker menu are not available for the Result Summary, Channel Table and CCDF
measurements.
Command
Marker 1
Marker 2
Marker 3
Marker 4
Marker Norm/Delta
All Marker Off
Percent Marker
Marker 1/Marker 2/Marker 3/Marker 4Marker Norm/Delta
The Marker <no> softkey activates the corresponding marker and opens an edit dialog box to
enter a value for the marker to be set to. Pressing the softkey again deactivates the selected
marker. If two screens are active in the Code Domain Analyzer, each of the screens has its own
set of markers.
Marker 1 is always the reference marker for relative measurements. If activated, markers 2 to 4
are delta markers that refer to marker 1. These markers can be converted into markers with
absolute value display by means of the Marker Norm/Delta softkey. If marker 1 is the active
marker, pressing the Marker Norm/Delta softkey switches on an additional delta marker.
For the Channel Bitstream measurement only one marker (Marker 1) is available. It can be used
for scrolling and to display the number and value of a bit.
Remote: CALC:MARK ON
Remote: CALC:MARK:X <value>
Remote: CALC:MARK:Y?
Remote: CALC:DELT ON
Remote: CALC:DELT:X <value>
Remote: CALC:DELT:X:REL?
Remote: CALC:DELT:Y?
All Marker Off
For details refer to the All Marker Off softkey in the marker menu of the base unit.
To Next Page
Loading...
