R&S FSL CDMA2000 BTS Analyzer (Option K82)
1300.2519.12 4.341 E-11
Softkeys of the trigger menu (CDMA2000 BTS Analyzer mode)
The following table shows all softkeys available in the trigger menu in CDMA2000 BTS Analyzer mode.
It is possible that your instrument configuration does not provide all softkeys. If a softkey is only
available with a special option, model or measurement mode, this information is delivered in the
corresponding softkey description.
Command
Trigger Source
Trigger Polarity Pos/Neg
Trigger Offset
Trigger Source
For details refer to the Trigger Source softkey of the IQ Capture Settings dialog box.
Trigger Polarity Pos/Neg
For details refer to the Trigger Polarity softkey of the IQ Capture Settings dialog box.
Trigger Offset
For details refer to the Trigger Offset softkey in the trigger menu of the base unit.
Softkeys of the trace menu (CDMA2000 BTS Analyzer mode)
The following table shows all softkeys available in the trace menu in CDMA2000 BTS Analyzer mode.
It is possible that your instrument configuration does not provide all softkeys. If a softkey is only
available with a special option, model or measurement mode, this information is delivered in the
corresponding softkey description.
Command
Trace Mode
Screen Focus A/B
Screen Size Full/Split
Scaling
Sweep Count
Trace Mode
Opens a dialog box, in which the trace mode can be selected. For details on the various trace
modes refer to the Trace mode overview on page 4.40.
Note that the Blank trace mode is not available for the code domain measurements. Also note
that the Trace Mode softkey is not available for the Result Summary measurement. This is
because in this measurement the minimum, mean and maximum values are already supported
(see Result Summary).
Remote: DISP:TRAC:MODE AVER
To Next Page
Loading...
