1xEV-DO BTS Analyzer (Option K84) R&S FSL
1300.2519.12 4.374 E-11
Meas
Initiates a measurement in Automatic Channel Search mode. The measurement results are
applied to the active channel table. The active channel table is overwritten without further notice.
The softkey is only available if the Auto Search mode is selected in the Channel Table
Settings dialog box.
Sort
Sorts the table according to the following rules.
First off, active channels are separated from inactive channels. Within these categories sorting is
then done first by the channel type and next by the spreading factor in ascending order. Last,
the sorting is done by the code number, also in ascending order.
Save
Saves the table under its specified name in the xml-format. If you edit a channel table and want
to keep the original channel table, change the name of the edited channel table before saving it.
Cancel
Closes the Edit dialog box and returns to the Channel Table Settings dialog box. Changes
applied to the channel table are lost.
Reload
Reloads the original content of the copied channel table.
Copy
Copies the selected table. All elements of the selected channel table are copied, except the
name which is set to 'Copy of <SourceChannelTableName>'.
The submenu is the same as that of the New softkey.
Remote: CONF:CDP:CTAB:COPY "CTAB2"
Delete
Deletes the selected channel table. The currently active channel table cannot be deleted.
Remote: CONF:CDP:CTAB:DEL "CTAB2"
To Next Page
Loading...
