Instrument Setup and Interface Configuration - SETUP Key R&S FSL
1300.2519.12 4.496 E-11
Edit Name
Sets the focus on the Name field to enter a file name. The extension is added automatically.
This softkey is available from firmware version 1.10.
Remote: CORR:TRAN:SEL <name>
Edit Unit
Sets the focus on the Unit field to select the unit.
This softkey is available from firmware version 1.10.
Remote: CORR:TRAN:UNIT <string>
Edit Value
Sets the focus to enter positions and values as frequency/level pairs. The entered data are also
displayed graphically. Using the Shift x or Shift y button, all entered values can be shifted in x
or y direction.
This softkey is available from firmware version 1.10.
Remote: CORR:TRAN:DATA <freq>,<level>
Interpolation Lin/Log
Sets the scaling of the x-axis to linear or logarithmic.
This softkey is available from firmware version 1.10.
Remote: CORR:TRAN:SCAL LIN|LOG
Save Factor
Saves the changed factor to a file on the internal flash disk. If a transducer factor with the same
name already exists, a confirmation query is displayed. If the new factor is active, the new
values are immediately applied.
This softkey is available from firmware version 1.10.
Remote: In remote control, the save operation is performed automatically after the definition of the
reference values.
New
Opens the Edit Transducer dialog box to enter data for a new factor.
This softkey is available from firmware version 1.10.
Copy to
Opens the Edit Transducer dialog box to copy the selected factor.
This softkey is available from firmware version 1.10.
To Next Page
Loading...
