Rohde & Schwarz R&S FSL3 - Page 774

R&S FSL CALCulate Subsystem
1300.2519.12 6.15 E-11
C
ALCulate<1|2>:DELTamarker<1...4>:FUNCtion:FIXed:RPOint:Y
This command defines a new reference point level for all delta markers for a measurement with
fixed reference point
(CALCulate<1|2>:DELTamarker<1...4>:FUNCtion:FIXed[:STATe]).
F
or phase–noise measurements
(CALCulate<1|2>:DELTamarker<1...4>:FUNCtion:PNOise[:STATe]), the command
defines a new reference point level for delta marker 2.
The numeric suffixes <1|2> are irrelevant for this command.
Parameter
<numeric_value>
Example
CALC:DELT:FUNC:FIX:RPO:Y –10dBm
Sets the reference point level for delta markers to –10 dBm.
Characteristics
RST value: – (CALCulate<1|2>:DELTamarker<1...4>:FUNCtion:FIXed[:STATe] is
set to OFF)
SCPI: device–specific
Mode
A
CALCulate<1|2>:DELTamarker<1...4>:FUNCtion:FIXed:RPOint:Y:OFFSet
This command defines an additional level offset for the measurement with fixed reference value
(CALCulate:DELTamarker:FUNCtion:FIXed:STATe ON). For this measurement, the
offset is included in the display of all delta markers.
For phase–noise measurements
(CALCulate<1|2>:DELTamarker<1...4>:FUNCtion:PNOise[:STATe]), the command
defines an additional level offset which is included in the display of delta marker 2.
The numeric suffixes <1|2> are irrelevant for this command.
Parameter
<numeric_value>
Example
CALC:DELT:FUNC:FIX:RPO:Y:OFFS 10dB
Sets the level offset for the measurement with fixed reference value or the phase–noise
measurement to 10 dB.
Characteristics
RST value: 0 dB
SCPI: device–specific
Mode
A