Rohde & Schwarz R&S FSL3 - Page 798

R&S FSL CALCulate Subsystem
1300.2519.12 6.39 E-11
C
ALCulate<1|2>:LIMit<1...8>:ACPower:ALTernate<1...11>:ABSolute:STATe
This command activates the limit check for the alternate adjacent channels for adjacent–
channel power measurement (Adjacent Channel Power).
Before the command, the limit check must be globally switched on for the channel/adjacent–
channel power with the CALCulate<1|2>:LIMit<1...8>:ACPower[:STATe] command.
The numeric suffix after ALTernate denotes the alternate channel. The numeric suffixes <1|2>
with CALCulate and <1...8> with LIMit are irrelevant for this command.
The result can be queried with
CALCulate<1|2>:LIMit<1...8>:ACPower:ALTernate<1...11>:RESult?. It should be
noted that a complete measurement must be performed between switching on the limit check
and the result query, since otherwise no correct results are available.
Parameter
ON | OFF
Example
CALC:LIM:ACP:ALT2 30DB, 30DB
Sets the relative limit value for the power in the lower and upper second alternate adjacent
channel to 30 dB below the channel power.
CALC:LIM:ACP:ALT2:ABS –35DBM, –35DBM
Sets the absolute limit value for the power in the lower and upper second alternate adjacent
channel to –35 dBm.
CALC:LIM:ACP ON
Switches on globally the limit check for the channel/adjacent channel measurement.
CALC:LIM:ACP:ALT2:STAT ON
Switches on the check of the relative limit values for the lower and upper second alternative
adjacent channels.
CALC:LIM:ACP:ALT2:ABS:STAT ON
Switches on the check of absolute limit values for the lower and upper second alternative
adjacent channels.
INIT;*WAI
Starts a new measurement and waits for the sweep end.
CALC:LIM:ACP:ALT2:RES?
Queries the limit check result in the second alternate adjacent channels.
Characteristics
*RST value: OFF
SCPI: device–specific
Mode
A, CDMA, EVDO