Rohde & Schwarz R&S FSL3 - Page 792

R&S FSL CALCulate Subsystem
1300.2519.12 6.33 E-11
CALCulate:LIMit:ACPower Subsystem
The CALCulate:LIMit:ACPower subsystem defines the limit check for adjacent channel power measurement.
Commands of the CALCulate:LIMit:ACPower Subsystem
– CALCulate<1|2>:LIMit<1...8>:ACPower[:STATe]
– CALCulate<1|2>:LIMit<1...8>:ACPower:ACHannel[:RELative]
– CALCulate<1|2>:LIMit<1...8>:ACPower:ACHannel[:RELative]:STATe
– CALCulate<1|2>:LIMit<1...8>:ACPower:ACHannel:ABSolute
– CALCulate<1|2>:LIMit<1...8>:ACPower:ACHannel:ABSolute:STATe
– CALCulate<1|2>:LIMit<1...8>:ACPower:ACHannel:RESult?
– CALCulate<1|2>:LIMit<1...8>:ACPower:ALTernate<1...11>[:RELative]
– CALCulate<1|2>:LIMit<1...8>:ACPower:ALTernate<1...11>[:RELative]:STATe
– CALCulate<1|2>:LIMit<1...8>:ACPower:ALTernate<1...11>:ABSolute
– CALCulate<1|2>:LIMit<1...8>:ACPower:ALTernate<1...11>:ABSolute:STATe
– CALCulate<1|2>:LIMit<1...8>:ACPower:ALTernate<1...11>:RESult?
CALCulate<1|2>:LIMit<1...8>:ACPower[:STATe]
This command switches on and off the limit check for adjacent–channel power measurements.
The CALCulate<1|2>:LIMit<1...8>:ACPower:ACHannel[:RELative]:STATe or
CALCulate<1|2>:LIMit<1...8>:ACPower:ALTernate<1...11>[:RELative]:STATe
commands must be used in addition to specify whether the limit check is to be performed for the
upper/lower adjacent channel or for the alternate adjacent channels.
The numeric suffixes <1|2> and <1...8> are irrelevant for this command.
Parameter
ON | OFF
Example
CALC:LIM:ACP ON
Switches on the ACP limit check.
Characteristics
*RST value: OFF
SCPI: device–specific
Mode
A, CDMA, EVDO
CALCulate<1|2>:LIMit<1...8>:ACPower:ACHannel[:RELative]
This command defines the relative limit of the upper/lower adjacent channel for adjacent–
channel power measurements. The reference value for the relative limit value is the measured
channel power.
It should be noted that the relative limit value has no effect on the limit check as soon as it is
below the absolute limit value defined with the
CALCulate<1|2>:LIMit<1...8>:ACPower:ACHannel:ABSolute command. This
mechanism allows automatic checking of the absolute basic values of adjacent–channel power
as defined in mobile radio standards.