Rohde & Schwarz R&S FSL3 - Page 801

CALCulate Subsystem R&S FSL
1300.2519.12 6.42 E-11
Example
CALC:LIM2:CONT:DOM TIME
Defines zero span for the x–axis of limit line 2.
Characteristics
*RST value: FREQuency
SCPI: device–specific
Mode
A, ADEMOD, CDMA, EVDO
CALCulate<1|2>:LIMit<1...8>:CONTrol:MODE
This command selects the relative or absolute scaling for the x–axis of the selected limit line.
The numeric suffixes <1|2> are irrelevant for this command.
This command is available from firmware version 1.10.
Parameter
RELative | ABSolute
Example
CALC:LIM2:CONT:MODE REL
Defines the x–axis of limit line 2 as relatively scaled.
Characteristics
*RST value: ABSolute
SCPI: device–specific
Mode
A, ADEMOD, CDMA, EVDO
CALCulate<1|2>:LIMit<1...8>:CONTrol:OFFSet
This command defines an offset for the x–axis value of the selected relative limit line for span >
0 or zero span.
In analyzer mode, the unit of values depends on the span setting of the x–axis. For details refer
to CALCulate<1|2>:LIMit<1...8>:CONTrol:DOMain.
The numeric suffixes <1|2> are irrelevant for this command.
This command is available from firmware version 1.10.
Parameter
<numeric_value>
Example
CALC:LIM2:CONT:OFFS 100us
Sets the X offset for limit line 2 (defined in zero span) to 100Us.
Characteristics
*RST value: 0
SCPI: device–specific
Mode
A, ADEMOD, CDMA, EVDO