R&S FSL CALCulate Subsystem
1300.2519.12 6.59 E-11
C
haracteristics
*RST value: –
SCPI: device–specific
M
ode
A, ADEMOD, CATV, CDMA, EVDO, SPECM, WCDMA
CALCulate<1|2>:MARKer<1...4>:MAXimum:AUTO
Activates the automatic peak search function for marker 1 at the end of each particular sweep.
This function may be used during adjustments of a device under test to keep track of the actual
peak marker position and level.
For CDMA2000 and 1xEV-DO code domain measurements (option K82 and K84) the numeric
suffix <1|2> selects the measurement screen. In the other modes the numeric suffix <1|2> is
irrelevant.
This command is available from firmware version 1.50.
Note: If no maximum value is found on the trace (level spacing to adjacent values < peak
excursion), an execution error (error code: –200) is produced.
Parameter
ON | OFF
Example
CALC:MARK:MAX:AUTO ON
Activates the automatic peak search function for marker 1 at the end of each particular sweep.
Characteristics
*RST value: OFF
SCPI: device–specific
Mode
A
CALCulate<1|2>:MARKer<1...4>:MAXimum:LEFT
This command positions the marker to the next smaller maximum value to the left of the current
value (i.e. in descending X values) on the trace.
For CDMA2000 and 1xEV-DO code domain measurements (option K82 and K84) the numeric
suffix <1|2> selects the measurement screen. In the other modes the numeric suffix <1|2> is
irrelevant.
This command is an event and therefore has no *RST value and no query.
Note: If no next smaller maximum value is found on the trace (level spacing to adjacent
values < peak excursion), an execution error (error code: –200) is produced.
Example
CALC:MARK2:MAX:LEFT
Positions marker 2 to the next lower maximum value to the left of the current value.
Characteristics
*RST value: –
SCPI: device–specific
Mode
A, ADEMOD, BT, CATV, CDMA, EVDO, SPECM, WCDMA
To Next Page
Loading...
