Rohde & Schwarz R&S FSL3 - Page 824

R&S FSL CALCulate Subsystem
1300.2519.12 6.65 E-11
C
ALCulate<1|2>:MARKer<1...4>:X:SLIMits:LEFT
This command sets the left limit of the search range for markers and delta markers. Depending
on the span setting of the x–axis the indicated value defines a frequency (span > 0) or time
(span = 0).
The numeric suffixes <1|2> and <1...4> are irrelevant for this command.
If the power measurement in zero span is active, this command limits the evaluation range to
the trace.
Note: The function is only available if the search limit for marker and delta marker is switched
on (CALCulate<1|2>:MARKer<1...4>:X:SLIMits[:STATe]).
Parameter
0 to MAX (frequency | sweep time)
Example
CALC:MARK:X:SLIM ON
Switches the search limit function on.
CALC:MARK:X:SLIM:LEFT 10MHz
Sets the left limit of the search range to 10 MHz.
Characteristics
*RST value: – (is set to the left diagram border when switching on search limits)
SCPI: device–specific
Mode
A, ADEMOD, CATV, SPECM
CALCulate<1|2>:MARKer<1...4>:X:SLIMits:RIGHT
This command sets the right limit of the search range for markers and delta markers. Depending
on the span setting of the x–axis the indicated value defines a frequency (span > 0) or time
(span = 0).
The numeric suffixes <1|2> and <1...4> are irrelevant for this command.
If the power measurement in zero span is active, this command limits the evaluation range to
the trace.
Note: The function is only available if the search limit for marker and delta marker is switched
on (CALCulate<1|2>:MARKer<1...4>:X:SLIMits[:STATe]).
Parameter
0 to MAX (frequency | sweep time)
Example
CALC:MARK:X:SLIM ON
Switches the search limit function on.
CALC:MARK:X:SLIM:RIGH 20MHz
Sets the right limit of the search range to 20 MHz.
Characteristics
*RST value: – (is set to the right diagram border when switching on search limits)
SCPI: device–specific
Mode
A, ADEMOD, CATV, SPECM