Rohde & Schwarz R&S FSL3 - Page 846

R&S FSL CALCulate Subsystem
1300.2519.12 6.87 E-11
CALCulate<1|2>:MARKer:FUNCtion:POWer[:STATe]
This command switches off the power measurement.
The numeric suffixes <1|2> are not relevant.
This command is an event and therefore has no *RST value.
Parameter
OFF
Example
CALC:MARK:FUNC:POW OFF
Switches off the power measurement.
Characteristics
*RST value: –
SCPI: device–specific
Mode
A–F
CALCulate<1|2>:MARKer:FUNCtion:POWer:MODe
This commands defines the method by which the channel power values are calculated from the
current trace.
The numeric suffixes <1|2> are not relevant.
This command is available from firmware version 1.30.
Parameter
WRITe The channel power and the adjacent channel powers are calculated directly
from the current trace
MAXHold The power values are calculated from the current trace and compared with
the previous power value using a maximum algorithm.
Example
CALC:MARK:FUNC:POW:MODE MAXH
Sets the Maxhold channel power mode.
Characteristics
*RST value: –
SCPI: device–specific
Mode
A–F