Rohde & Schwarz R&S FSL3 - Page 856

R&S FSL CALCulate Subsystem
1300.2519.12 6.97 E-11
C
ALCulate<1|2>:MARKer:FUNCtion:SUMMary[:STATe]
This command switches on or off the previously selected power measurements in zero span.
Thus one or several measurements can be first selected and then switched on and off together
with CALCulate<1|2>:MARKer:FUNCtion:SUMMary[:STATe].
T
he numeric suffixes <1|2> are not relevant.
Parameter
ON | OFF
Example
CALC:MARK:FUNC:SUMM:STAT ON
Characteristics
*RST value: OFF
SCPI: device–specific
Mode
A–T
CALCulate<1|2>:MARKer:FUNCtion:SUMMary:AOFF
This command switches off all measurements in zero span.
The numeric suffixes <1|2> are not relevant.
This command is an event and therefore has no *RST value and no query.
Example
CALC:MARK:FUNC:SUMM:AOFF
Switches off the functions for power measurement in zero span.
Characteristics
*RST value: –
SCPI: device–specific
Mode
A–T
CALCulate<1|2>:MARKer:FUNCtion:SUMMary:AVERage
This command switches on or off averaging for the active power measurement in zero span.
Averaging is reset by switching it off and on again.
The number of results required for the calculation of average is defined with
[SENSe<1|2>:]AVERage:COUNt.
Synchronization to the end of averaging is only possible in single sweep mode.
The numeric suffixes <1|2> are not relevant.
Parameter
ON | OFF
Example
INIT:CONT OFF
Switches to single sweep mode.
CALC:MARK:FUNC:SUMM:AVER ON
Switches on the calculation of average.