Rohde & Schwarz R&S FSL3 - Page 857

CALCulate Subsystem R&S FSL
1300.2519.12 6.98 E-11
AVER:COUN 200
Sets the measurement counter to 200.
INIT;*WAI
Starts a sweep and waits for the end.
Characteristics
*RST value: OFF
SCPI: device–specific
Mode
A–T
CALCulate<1|2>:MARKer:FUNCtion:SUMMary:MEAN[:STATe]
This command switches on or off the measurement of the mean value.
The numeric suffixes <1|2> are not relevant.
Note: The measurement is performed on the trace on which marker 1 is positioned. In order to
evaluate another trace, marker 1 must be positioned on another trace with
CALCulate<1|2>:MARKer<1...4>:TRACe.
Parameter
ON | OFF
Example
CALC:MARK:FUNC:SUMM:MEAN ON
Switches on the function.
Characteristics
*RST value: OFF
SCPI: device–specific
Mode
A–T
CALCulate<1|2>:MARKer:FUNCtion:SUMMary:MEAN:AVERage:RESult?
This command queries the result of the measurement of the averaged mean value. The query is
only possible if averaging has been activated previously using
CALCulate<1|2>:MARKer:FUNCtion:SUMMary:AVERage.
A complete sweep with synchronization to sweep end must be performed between switching on
the function and querying the measured value to obtain a correct query result. This is only
possible in single sweep mode.
The numeric suffixes <1|2> are not relevant.
This command is only a query and therefore has no *RST value.
Example
INIT:CONT OFF
Switches to single sweep mode.
CALC:MARK:FUNC:SUMM:MEAN ON
Switches on the function.
CALC:MARK:FUNC:SUMM:AVER ON
Switches on the average value calculation.
INIT;*WAI
Starts a sweep and waits for the end.