HCOPy Subsystem R&S FSL
1300.2519.12 6.140 E-11
HCOPy[:IMMediate<1|2>]:NEXT
This command starts a hardcopy output. The numeric suffix selects which printer configuration
(device 1 or 2) is to be used for the hardcopy output. If there is no suffix, configuration 1 is
automatically selected. If the output is printed to a file (see HCOPy:DESTination<1|2>
command), the file name used in the last saving process is automatically counted up to the next
unused name.
This command is an event and therefore has no *RST value and no query.
This command is available from firmware version 1.70.
Example
HCOP:DEV:LANG BMP
Selects the data format.
HCOP:DEST 'MMEM'
Directs the hardcopy to a file.
MMEM:NAME 'C:\R_S\instr\user\Print.bmp'
Selects the file name.
HCOP
Saves the hardcopy output into the file Print.bmp.
HCOP:NEXT
Saves the hardcopy output into the file Print_001.bmp.
HCOP:NEXT
Saves the hardcopy output into the file Print_002.bmp.
Characteristics
RST value: -
SCPI: device-specific
Mode
all
HCOPy:ABORt
This command aborts a running hardcopy output.
This command is an event and therefore has no *RST value and no query.
Example
HCOP:ABOR
Characteristics
*RST value: -
SCPI: conform
Mode
all
To Next Page
Loading...
