HCOPy Subsystem R&S FSL
1300.2519.12 6.142 E-11
HCOPy:CMAP<1...26>:PDEFined
This command defines the color table in user defined colors using predefined color values. To
each numeric suffix of CMAP is assigned one or several picture elements which can be modified
by varying the corresponding color setting. For details on the CMAP assignment refer to "CMAP
suffix assignment" on page 6.127.
The values set are not changed by *RST.
This command is available from firmware version 1.10.
Parameter
BLACk | BLUE | BROWn | GREen | CYAN | RED | MAGenta | YELLow | WHITe | DGRAy |
LGRAy | LBLUe | LGREen | LCYan | LRED | LMAGenta
Example
HCOP:CMAP2:PDEF GRE
Characteristics
*RST value: -
SCPI: conform
Mode
all
HCOPy:DESTination<1|2>
This command selects the printer output medium (Disk, Printer or Clipboard) associated with
configuration 1 or 2.
Note: The type of instrument is selected with SYSTem:COMMunicate:PRINter:SELect
<1|2>, which will automatically select a default output medium. Therefore the
HCOPy:DESTination<1|2> command should always be sent after setting the device
type.
Parameter
MMEM
Directs the hardcopy to a file. The MMEMory:NAME command
defines the file name. All formats can be selected for
HCOPy:DEVice:LANGuage<1|2>.
SYST:COMM:PRIN Directs the hardcopy to the printer. The printer is selected with
the SYSTem:COMMunicate:PRINter:SELect <1|2>
command.
GDI should be selected for
HCOPy:DEVice:LANGuage<1|2>.
SYST:COMM:CLIP Directs the hardcopy to the clipboard. EWMF should be
selected for HCOPy:DEVice:LANGuage<1|2>.
Example
SYST:COMM:PRIN:SEL2 'LASER on LPT1'
Selects the printer and output medium for device 2.
HCOP:DEST2 'SYST:COMM:PRIN'
Selects the printer interface as device 2.
To Next Page
Loading...
