Rohde & Schwarz R&S FSL3 - Page 944

R&S FSL SENSe Subsystem
1300.2519.12 6.185 E-11
[
SENSe<1|2>:]CORRection:TRANsducer:VIEW
This command switches on the display of the active transducer factor or set.
Note: Prior to this command, the [SENSe<1|2>:]CORRection:TRANsducer:SELect
command must be sent.
This command is available from firmware version 1.10.
Parameter
ON | OFF
Example
CORR:TRAN:VIEW ON
Characteristics
*RST value: OFF
SCPI: device-specific
Mode
A