Rohde & Schwarz R&S FSL3 - Page 943

SENSe Subsystem R&S FSL
1300.2519.12 6.184 E-11
[SENSe<1|2>:]CORRection:TRANsducer:SELect
This command selects the transducer factor designated by <name>. If <name> does not exist
yet, a new transducer factor is created.
Note: This command must be sent prior to the subsequent commands for modifying/activating
t
ransducer factors.
This command is available from firmware version 1.10.
Parameter
<name> = Name of the transducer factor in string data form with a maximum of 8 characters.
Example
CORR:TRAN:SEL 'FACTOR1'
Characteristics
*RST value: -
SCPI: device-specific
Mode
A
[SENSe<1|2>:]CORRection:TRANsducer:UNIT
This command defines the unit of the transducer factor selected.
Note: Prior to this command, the [SENSe<1|2>:]CORRection:TRANsducer:SELect
command must be sent.
This command is available from firmware version 1.10.
Parameter
<string> = DB | DBM | DBMV | DBUV | DBUV/M | DBUA DBUA/M | DBPW | DBPT
Example
CORR:TRAN:UNIT 'DBUV'
Characteristics
*RST value: DB
SCPI: device-specific
Mode
A