Rohde & Schwarz R&S FSL3 - Page 954

R&S FSL SENSe Subsystem
1300.2519.12 6.195 E-11
[SENSe<1|2>:]ESPectrum:RANGe<1...20>:INSert
This command inserts a new range before or after the specified range. The range numbers are
updated accordingly.
The numeric suffixes <1...20> specify the range. The numeric suffixes <1|2> are not relevant.
This command is available from firmware version 1.80.
Parameter
AFTer | BEFore
Example
ESP:RANG3:INS BEF
Inserts a new range before range 3.
ESP:RANG1:INS AFT
Inserts a new range after range 1.
Characteristics
RST value:
SCPI: device–specific
Mode
A, CDMA, EVDO
[SENSe<1|2>:]ESPectrum:RANGe<1...20>:LIMit:ABSolute:STARt
This command sets an absolute limit value at the start frequency of the specified range.
Different from manual operation, this setting is independently of the defined limit check type.
The numeric suffixes <1...20> specify the range. The numeric suffixes <1|2> are not relevant.
This command is available from firmware version 1.80.
Parameter
–400 to in 400 dBm
Example
ESP:RANG1:LIM:ABS:STAR 10
Sets an absolute limit of 10 dBm at the start frequency of the range.
Characteristics
RST value: –13 dBm
SCPI: device–specific
Mode
A, CDMA, EVDO
[SENSe<1|2>:]ESPectrum:RANGe<1...20>:LIMit:ABSolute:STOP
This command sets an absolute limit value at the stop frequency of the specified range.
Different from manual operation, this setting is independently of the defined limit check type.
The numeric suffixes <1...20> specify the range. The numeric suffixes <1|2> are not relevant.
This command is available from firmware version 1.80.
Parameter
–400 to in 400 dBm