Rohde & Schwarz R&S FSL3 - Page 962

R&S FSL SENSe Subsystem
1300.2519.12 6.203 E-11
[
SENSe<1|2>:]FREQuency:OFFSet
This command defines the frequency offset of the instrument.
T
he numeric suffixes <1|2> are not relevant.
Parameter
–100 GHz to 100 GHz
Example
FREQ:OFFS 1GHZ
Characteristics
*RST value: 0 Hz
SCPI: conform
Mode
A, ADEMOD, CDMA, EVDO, WCDMA
[SENSe<1|2>:]FREQuency:SPAN
This command defines the frequency span in the Spectrum Analyzer mode.
The numeric suffixes <1|2> are not relevant.
Parameter
0 to f
max
f
max
is specified in the data sheet. To help analyze signals located at the end of the frequency
range, for R&S FSL models with an upper frequency limit of 6 GHz or less, the f
max
value is
extended by 0.05 GHz for direct entry. The preset and maximum values remain unchanged.
Example
FREQ:SPAN 10MHz
Characteristics
*RST value: f
max
with f
max
= maximum frequency
SCPI: conform
Mode
A, CATV, CDMA, EVDO
[SENSe<1|2>:]FREQuency:SPAN:FULL
This command sets the frequency span to its maximum.
The numeric suffixes <1|2> are not relevant.
Parameter
f
max
, specified in the data sheet.
Example
FREQ:SPAN:FULL
Characteristics
*RST value: –
SCPI: conform
Mode
A, CATV, CDMA, EVDO