2.14.8.1 SNMP V1/V2c
SNMP V1 is the first version of the SNMP protocol, as defined in the IETF (Internet
Engineering Task Force) RFCs (Request for Comments) number 1155 and 1157.
SNMP V2c is the revised protocol, but it also uses the V1 community based admin-
istration model.
Creating Communities
1.
Navigate to MANAGEMENT > NETWORK: SNMP Setup.
2.
In the SNMP V1/V2 panel click the PLUS icon in the top-right corner.
3.
The SNMP V1/V2c Settings for Access window will display:
4. Enter the required information in the fields provided:
The IP Version field provides a choice of IPv4, IPV6 or both IPv4 and
IPv6 (= default).
The choices offered below will change in context with the choice
made in the IP Version field.
If no value is entered in the IPv4 and/or IPv6 field, SecureSync uses
the system default address.
SNMP Community names should be between 4 and 32 characters in
length.
Permissions may be Read Only or Read/Write.
The Version field provides a choice of V1 or V2c.
2.14 Configure Network Settings
CHAPTER 2 • SecureSync 2400 User Manual Rev. 5.2
105
To Next Page
Loading...
