Safran SecureSync 2400 - Required Tools and Parts; Required GNSS Antenna Components

Purchased optional equipment (note that option cards listed on the pur-
chase order will be pre-installed in the unit). See "Option Card Iden-
tification" on page20 and "Option Cards Overview" on page17.
2.3 Required Tools and Parts
Depending on your application and system configuration, the following tools and
parts may be required:
Phillips screwdrivers to install the rack-mount ears, and to mount the unit in
a 19"-rack
Ethernet cables (see "Connecting Network Cables" on page51).
2.3.1 Required GNSS Antenna Components
Should you plan on using a GNSS reference with your SecureSync, you will also
need the following items (sold separately):
Antenna cable with SMA connector, or conversion cable
Note: The SMA-to-N-type conversion cable included in the
ancillary kit is approved for pull weight of up to 60 lbs. If you
are using a heavier cable, you will need to apply appropriate
strain relief.
GNSS antenna with mounting bracket
GNSS antenna surge suppressor (recommended)
GNSS antenna inline amplifier (optional for short cable lengths)
For antenna installation guidelines, see the separate documentation shipped with
the antenna components.
44
CHAPTER 2 • SecureSync 2400 User Manual Rev. 5.2
2.3 Required Tools and Parts