Safran SecureSync 2400 - Resetting the GNSS Receiver; Deleting the GNSS Receiver Position

3.3.3.7 Resetting the GNSS Receiver
The Reset Receiver command causes the GNSS receiver to execute a cold start:
All data will be erased from the volatile receiver memory. Only non- volatile
memory is preserved.
Caution: Resetting the GNSS receiver may become necessary in the
rare event of internal communication issues, and is typically ONLY
required if Safran Technical Support advises you to execute this com-
mand.
Note that resetting the GNSS receiver is not the same as "Deleting the GNSS
Receiver Position" below.
To reset the GNSS Receiver:
1.
Navigate to Interfaces > References: GNSS Reference
2.
Click on the GEAR button next to the GNSS Reference. The GNSS0 win-
dow opens:
3.
Locate the Reset Receiver box, check it, and click Submit.
3.3.3.8 Deleting the GNSS Receiver Position
The SecureSync timing system requires the exact geographic position in order to
calculate the exact system time from the GNSS signal.
The Delete Position command deletes the GNSS antenna position data that is
stored in the non-volatile memory of the GNSS receiver.
The deletion of the position data will automatically initiate a new GNSS self sur-
vey, provided:
3.3 Managing References
CHAPTER 3 • SecureSync 2400 User Manual Rev. 5.2
239