Safran SecureSync 2400 - Notification Event Types; Timing Tab: Events

Mask Alarm—Check here to enable an alarm mask. Enabling an alarm
mask for a given notification will prevent that notification from gen-
erating an alarm condition. Other notifications for that event and log-
ging of the event will still occur.
SNMP Trap—Check here to configure the event to trigger an SNMP
Trap.
Email—Check here to configure the event to trigger an email noti-
fication.
Email Address—Enter the address to which the email should be sent
when triggered by the event.
Note: Each event can be configured with the desired email
address that is specific to just that one event only. Note that
only one email address can be specified in each Email Address
field.
For each event choose the notification you want and an email address – if
any – to which you want the notification to be sent. For more information,
see "SNMP" on page100 and "Setting Up Email Notifications" on page269.
For each event, only the notification options available can be configured.
For example, a mask alarm can be set for an In-Sync event, and a Not-in-
Sync event, but not for an In-Holdover event.
4.2.2 Notification Event Types
The following types of events can be used to trigger notifications:
4.2.2.1 Timing Tab: Events
In Sync
Not In Sync
In Holdover
No Longer in Holdover
Frequency Error
Frequency Error Cleared
1PPS Not In Specification
1PPS Restored to Specification
266
CHAPTER 4 • SecureSync 2400 User Manual Rev. 5.2
4.2 Notifications