Perform clean update: Factory settings will be applied during the
upgrade; any custom settings you may have applied previously will
be overwritten! This also includes the unit's static IP address (if you
applied one): it will be replaced by the default DHCP address (i.e.,
0.0.0.0.) Also note that the browser session will terminate: After
reconfiguring the unit's IP address, you will need to login to the Web
UI in a new browser session.
6.
Click Submit to carry out the update. A progress bar will provide real-time
status information:
7.
Verify that the update was successful: Navigate to Tools >
Upgrade/Backup, and confirm the new SW version in the System Con-
figuration panel.
Note: Should you use DHCP, a new IP address may be assigned to
your unit, and you may have to point your web browser to it.
Note: In the event that the update failed, see "Troubleshooting Soft-
ware Update" on page360.
4.6.2 Applying a License File
Software options must be activated by applying a license file (OPT-xyz):
Typically, SecureSync units are shipped with the license file pre-installed, reflect-
ing the system configuration as ordered. If, however, a feature is to be activated
after delivery of the SecureSync unit, please contact your local Safran Sales
Office first to have a license file generated. License files are archive files with a
tar.gz extension. One license file may contain multiple licenses for multiple
products.
To apply the license file, you need to upload it into your SecureSync unit and
install it:
4.6 Updates and Licenses
CHAPTER 4 • SecureSync 2400 User Manual Rev. 5.2
339
To Next Page
Loading...
