Safran SecureSync 2400 - Configure Network Settings

Caution: For security reasons, it is advisable to change the
default credentials, see: "Managing Passwords" on page278.
4. Upon initial login, you will be asked to register your product. Safran recom-
mends to register SecureSync, so as to receive software updates and ser-
vices notices. See also "Product Registration" on page301.
Number of login attempts
The number of failed login attempts for ssh is hard-set to (4) four. This value is
not configurable.
The number of failed login attempts for the Web UI (HTTP/HTTPS) is hard-set to
(5) five failed login attempts, with a 60 second lock. These two values are not con-
figurable.
To continue with the configuration, see e.g., "The Web UI HOME Screen" on
page34.
To learn more about setting up different types of user accounts, see "Managing
User Accounts" on page273.
2.14 Configure Network Settings
Before configuring the network settings, you need to setup access to SecureSync
web user interface ("Web UI"). This can be done by assigning a static IP address,
or using a DHCP address. For more information, see "Setting up an IP Address"
on page64.
Once you have assigned the IP address, login to the Web UI. For more inform-
ation, see "Accessing the WebUI" on page71.
To configure network settings, or monitor your network, navigate to
SecureSync's Network Setup screen.
To access the Network Setup screen:
Navigate to MANAGEMENT > Network Setup. The Network Setup screen
is divided into three panels:
2.14 Configure Network Settings
CHAPTER 2 • SecureSync 2400 User Manual Rev. 5.2
73