2.18.3 Assigning Signals
Changing the signals on either the rear panel BNC DCLS connector, or on the
Multi I/O 15-pin connector requires access to the Web UI.
Configuring a new Input or Output
1.
In the SecureSync Web UI, navigate to MANAGEMENT > NETWORK: Pin
Layout. The Pin Layout screen will be displayed.
2. View your current pin layout settings in the Layout panel. The pins are
grouped together by their channels (see the "Multi I/O 15-pin connector, in
mating direction from front" on the previous page). One pin in each channel
will update the settings for the entire channel.
3.
To change a signal, you can Delete it, but you may also simply assign the
new signal as described below, thus overwriting the existing Input or Out-
put.
4. Add a pin configuration by clicking the PLUS icon in the top-right corner.
The Add Pin popup window will display.
5.
Start with the Type Filter drop-down menu (second line in the window)
and select a signal type.
6.
From the Signal drop-down menu, select a signal.
7.
From the Pins drop-down menu in line 3, select the pin set you wish to con-
figure.
8.
Click Submit.
9.
In the Actions panel, click Apply Changes after all your configuration is
done. This button will finalize your changes and force a server reboot
(some timing sources may be affected by this change).
Restoring the Default I/O Configuration
SecureSync is shipped with a default I/O configuration that you can be cus-
tomized. However, if required you can restore the default configuration at any
time after applying changes.
To restore the default I/O pin configuration:
A.
Navigate to the MANAGEMENT: NETWORK > Pin Layout screen.
B.
In the Actions panel on the left, click Restore Default Layout.
Reloading the Current I/O Configuration
To reload the currently used I/O configuration after adding pin layout changes,
but before clicking Apply Changes:
160
CHAPTER 2 • SecureSync 2400 User Manual Rev. 5.2
2.18 Configurable Connectors
To Next Page
Loading...
