Mark as Preferred: Click here to make this server the preferred
server. For more information, see "Configuring "NTP Stratum 1" Oper-
ation" on page121.
Note: It is not normally recommended to select more
than one NTP Server in the NTP Servers table as being
Preferred. Typically, only one NTP server should be selec-
ted as Preferred.
5. Click Submit, or press Enter.
2.15.8.3 NTP Peers: Adding, Configuring, Removing
To add, configure, or remove an NTP Peer:
1.
Navigate to MANAGEMENT > NETWORK: NTP Setup.
2.
The NTP Setup screen appears. The NTP Peers panel displays a list of
recognized NTP peers.
Note: Should the list be empty, no servers have been added
yet. In the event that added peers are not displayed, they could
not be resolved. Verify the IPaddress
To EDIT the settings of an NTP Peer, click the GEAR button next to it,
and proceed to Step3 below.
To ADD a new NTP Peer, click the PLUS icon in the top right corner of
the NTP Peers panel.
To REMOVE an NTP Peer (and its associated configurations), click
the X-button next to it.
3.
The NTP Peers edit window opens:
128
CHAPTER 2 • SecureSync 2400 User Manual Rev. 5.2
2.15 Configure NTP
To Next Page
Loading...
