Safran SecureSync 2400 - Setting up SNMP Notifications; Setting up Email Notifications

3.
In the Minimum Satellites fields enter the minimum number of satellites
that must be available before the alarm is triggered. The alarm will be
triggered when the number of satellites available is BELOW this number.
4.
In the Duration Below Threshold (s) fields, enter the time in seconds that
the system must be below the threshold set in the Minimum Satellites field
before an alarm is triggered. The alarm will be triggered when this time is
reached.
By default, this timeout value is set to 0 seconds: As soon as the receiver
drops below the minimum number of satellites, the associated alarm is
triggered. A delay of e.g., 5 seconds, however, would not trigger an alarm if
the number of received satellites drops below the specified number for
only 3 seconds.
You can configure this event to cause either a Minor alarm, or a Major alarm, or
both.
To learn more about Minor and Major alarms, see "Minor and Major Alarms" on
page352.
Note that the GNSS receiver must initially be tracking more than the configured
number of satellites in order for this alarm to be triggered (the alarm is triggered
when the receiver falls below the number of Minimum Satellites you specified
above).
4.2.4 Setting Up SNMP Notifications
SNMP Notifications are SNMP traps that occur on a change of a monitored event.
To configure SNMP notifications:
1.
Navigate to MANAGEMENT > OTHER: Notifications.
2.
In the Actions panel, click SNMP Setup.
For more information on SNMP, see "SNMP" on page100.
4.2.5 Setting Up Email Notifications
The Email Setup window provides a means to configure SecureSync with the
necessary settings to interface it with Exchange email servers and Gmail.
To set up Notification Emails (Standard Mode):
4.2 Notifications
CHAPTER 4 • SecureSync 2400 User Manual Rev. 5.2
269