Safran SecureSync 2400 - The NTP Servers and NTP Peers Panels

the network that it is now at Stratum15. A status of Stratum15 will cause the net-
work to ignore SecureSync as an NTP time reference.
For more information about Holdover, see "Holdover Mode" on page246.
2.15.8.1 The NTP Servers and NTP Peers Panels
The NTP Servers and NTP Peers panels display which servers in the network are
set up at higher or equal Stratums (Servers or Peers, respectively), and their con-
figurations. These panels are also used to add, configure, or remove NTP Servers
and Peers.
Note: For information on how to view NTP Clients, see "Viewing NTP
Clients" on page118.
The NTP Servers and NTP Peers panels are part of the NTP Setup screen (see
"The NTP Setup Screen" on page114), which can be accessed via MANAGEMENT
> NETWORK: NTP Setup.
Information provided in the NTP Servers and NTP Peers panels
The following columns are used to break down the status information for recog-
nized NTP Servers and NTP Peers.
Note: Servers will be displayed in the Status view only if they can be
resolved. They will, however, always be displayed in the Setup view in
order to reconfigure them, if necessary.
124
CHAPTER 2 • SecureSync 2400 User Manual Rev. 5.2
2.15 Configure NTP