Safran SecureSync 2400 - Hot Swap Power Supply

A +24/48V
DC
power supply can optionally be used as an AC input: Safran offers
a kit containing an AC/DC converter with assembled DC connector: The part
number for this adapter kit is PS06R-2Z1M-DT01.
Figure 2-6: DC to AC Converter
2.9.3 Hot Swap Power Supply
DANGER! Remove the connected power source BEFORE attempting
to remove a power sled for replacement.
Caution: Only use Safran-approved replacement parts. Incorrect
parts may cause damage to the product.
The hot swap power supply (HSPS) option consists of two bays with redundant
power systems. The sleds in the unit can be a mix of AC and DC power supplies.
When both power supplies are active, the electrical draw is shared between the
two bays. If one power supply is damaged or removed, the other bay will auto-
matically take the entire power load without any additional configuration.
56
CHAPTER 2 • SecureSync 2400 User Manual Rev. 5.2
2.9 Connecting Supply Power