5.2.2.14 [11]: Verifying HW Detection and SW Update
Complete the Option Card installation procedure by verifying that SecureSync
detected the card, and by updating the system software:
a. Re-install the top cover of the unit chassis (housing), using the saved
screws.
Caution: Ensure that screw holes on the card are properly lined
up and secured to the chassis before powering the unit up, oth-
erwise damage to the equipment may result.
b. Power on the unit.
c. Verify the successful installation by ensuring the card has been detected:
Open a web browser, log in to the SecureSync WebUI, and navigate to
INTERFACES > OPTION CARDS: The new card will be displayed in the list.
If the card does not appear to be properly identified, proceed with the Soft-
ware update as described below, and then navigate to INTERFACES >
OPTION CARDS again to confirm the card has been detected.
If the card has been detected properly, proceed with the Software update
as described below to ensure SecureSync and the newly installed card are
using the same, latest available version.
Updating the System Software
Even if the newly installed option card has been detected, and even if the latest
System Software version is installed on your SecureSync unit, you must (re-)i-
install the software to ensure both SecureSync, and the option card are using the
latest software:
Follow the System Software update procedure, as outlined under "Soft-
ware Updates" on page338.
NEXT: Restore your reference priority configuration, as described in the following
topic, and configure other option card-specific settings, as described in the main
User Manual.
SecureSync 2400 User Manual 385
APPENDIX
To Next Page
Loading...
