Safran SecureSync 2400 - Network Ports; Configuring Input References

A.
Navigate to the MANAGEMENT: NETWORK > Pin Layout screen.
B.
In the Actions panel on the left, click Reload Layout.
Saving your unique Pin Layout
Before you perform a clean upgrade or restore your unit's default settings, you
can choose to download your current pin layout settings.
(Note: The Save Layout option applies only to the pin configuration for the DCLS
BNC connector and the 15-pin I/O connector. To save your entire configuration
including these settings, see "Backing-up and Restoring Configuration Files" on
page340.)
1.
To save the current layout, navigate to the MANAGEMENT > NETWORK >
Pin Layout screen.
2.
In the Actions panel, click the Save Layout button to download a file con-
taining your current settings.
3. Save this file in a location of your choosing and perform any necessary
actions.
4.
To restore your former layout, click the Upload Layout button in the Pin
Layout screen.
5. Choose the name and location of the file saved when using the Save Layout
function. Click the Upload button.
2.18.4 Network Ports
The Network Ports can be configured under MANAGEMENT > Network Setup.
For more information, see "Configure Network Settings" on page73.
2.19 Configuring Input References
Depending on the type of input reference, some of its settings may be user-edit-
able. To access these settings for a given input reference, choose one of the two
methods described below.
(To disable references or change the priority that your timing system will be
guided by those references, visit "Configuring Input Reference Priorities" on
page205).
2.19 Configuring Input References
CHAPTER 2 • SecureSync 2400 User Manual Rev. 5.2
161