Safran SecureSync 2400 - Unpacking and Inventory

5. Connect Input References such as your GNSS antenna, and network cable
(s): "Connecting the GNSS Input" on page50, and "Connecting Network
Cables" on page51.
6. Connect your power supply/-ies: "Connecting Supply Power" on page52.
7. Power up the unit: "Powering Up the Unit" on page260.
8. Setup basic network connectivity.…
i. …via front panel keypad and information display: "Setting Up an IP
Address via the Front Panel" on page66
ii. …or via serial port, using a PC with a CLI: "Setting Up an IP Address via
the Serial Port" on page69
iii. …or via Ethernet, using a PC with a web browser, and the SecureSync
Web UI: "Accessing the WebUI" on page71.
9. Register your product: "Product Registration" on page301.
2.2 Unpacking and Inventory
Caution: Electronic equipment is sensitive to Electrostatic Discharge
(ESD). Observe ESD precautions and safeguards when handling the
unit.
Unpack the equipment and inspect it for damage. If any equipment has been
damaged in transit, or you experience any problems during installation and con-
figuration of your Safran product, please contact Safran (see "Technical Support"
on page605).
Note: Retain original packaging for use in return shipments if neces-
sary.
The following items are included with your shipment:
SecureSync unit
QuickStart Guide (printed version)
Ancillary items (except for rack mounting items, the contents of this kit
may vary based on equipment configuration and/or regional requirements)
2.2 Unpacking and Inventory
CHAPTER 2 • SecureSync 2400 User Manual Rev. 5.2
43