NTP ON/OFF: This switch enables and disables NTP. See "Dis-/Enabling
NTP" below.
Note: When applying any changes NTP will usually restart auto-
matically. Use this switch only to force a restart.
Expert Mode: Turning this switch ON enables direct access to the NTP.-
conf file, thus bypassing the SecureSync Web UI. [Default =OFF] See "NTP
Expert Mode" on page146.
Note: Safran Tech Support does not support the editing of the
NTP configuration files in Expert Mode. For additional inform-
ation on editing the NTP.conf file, please refer to
http://www.ntp.org.
Other NTP Services that can be configured via the NTP Services panel by click-
ing the GEAR icon are:
Stratum 1 (see "NTP Reference Configuration" on page120)
The NTP Status Summary panel
… provides a real-time overview of your key NTP network parameters. For more
information, see "NTP Status Monitoring" on page317.
2.15.3 Dis-/Enabling NTP
If you applied NTP configuration changes e.g., added a new NTP Server,
SecureSync usually will stop and re-start the NTP Service automatically once you
clicked Submit. Changes made to NTP configurations will also take effect after
SecureSync is either rebooted or power-cycled.
You can, however, also disable or enable the SecureSync NTP Service manually.
To disable and enable your NTP Service:
1.
Navigate to MANAGEMENT > NETWORK: NTP Setup.
2.
In the NTP Services panel, set the ON/OFF toggle switch to OFF.
3. A notification window will confirm the status change.
4.
In the NTP Services panel, set the ON/OFF toggle switch to ON again.
Changes made will now take effect and NTP operation will be restored shortly
after this operation is performed.
2.15 Configure NTP
CHAPTER 2 • SecureSync 2400 User Manual Rev. 5.2
117
To Next Page
Loading...
