Safran SecureSync 2400 - Page 145

4. Enter the required information into the fields:
Host: The IPaddress for the server to be used as host.
Min Poll Interval: Select a value from the drop down (the default is 3
(8s).
Max Poll Interval: Select a value from the drop down (the default is 3
(8s).
For both NTP Peers, and NTP Servers the Minimum and Maximum Poll
rate for NTP packets can be configured.
Enable Symmetric Key: Click the checkbox to enable/disable Sym-
metric Key. See also: "Configuring NTP Symmetric Keys" on the next
page.
Note: Before you can edit the Key field, you must set up
Symmetric Keys through the Actions Panel. See "NTP:
Symmetric Keys (MD5) " on the next page.
Mark as Preferred: Check this box to prefer this NTP Peer over other
NTP Peers ("NTP Peer Preference"). This will result in SecureSync syn-
chronizing more frequently with this Peer. For additional information
on NTP Preferences, see "Configuring "NTP Stratum 1" Operation" on
page121.
2.15 Configure NTP
CHAPTER 2 • SecureSync 2400 User Manual Rev. 5.2
129