Note: The Restore Defaults button in each PTP Settings panel will
only apply to the configuration of the Ethernet port that is currently
open.
Settings changed by the user will be maintained when the PTPdaemon is
stopped and started, and between reboots and power cycles.
Figure 2-13: Edit PTP Settings panel
Profile
PTP profile selection beyond Default will result in new fields and parameters, and
default values. See the Protocol tab section below for default values for the
Default profile.
Default Standard presets and defaults for PTPfunctionality.
Telecom G.8265.1: [Full Timing Support] Defaults: Unicast is required,
Domain is set to 4.
Power Utility 61850- 9- 3: Defaults: Peer Delay Mechanism, with an
announce rate of 1 message per second, Ethernet Network Transport, and
available Peer MAC Address field.
Power System C37.238: Defaults: Peer Delay Mechanism, with an
announce rate of 1 message per second, Ethernet Network Transport, avail-
able Peer MAC Address and Alt Timescale Display Name fields.Domain is
set to 254.
Protocol tab
The displayed defaults and available fields visible in this tab will change in
response to your Profile, Delay Mechanism, Mode, and Communication Mode
selections.
2.16 Configuring PTP
CHAPTER 2 • SecureSync 2400 User Manual Rev. 5.2
151
To Next Page
Loading...
