Refer to "The Time Management Screen" on page186 for more inform-
ation on configuring and reading the System Clock. Local timescale
allows a Local Clock to apply a time offset for Time Zone and DST cor-
rection.
Note: The Timescale of the input (as configured in the ASCII time
source) must be set correctly, especially if other input references are
enabled. Failure to configure the Timescale of the input correctly
could result in time jumps occurring in the System Time when input
reference changes occur. These time jumps could affect NTP and nor-
mal operation of the system.
Baud Rate: Determines the speed that the output port will operate at.
Data Bits: Defines the number of Data Bits for the output port.
Parity: Configures the parity checking of the output port.
Stop Bits: Defines the number of Stop Bits for the output.
Event Broadcast Output: Status Window
To view the current settings of the Event Broadcast Output, go to its Status win-
dow. For instructions, see: "Viewing Input/Output Configuration Settings" on
page363.
The Web UI list entry for this card is: Event Broadcast.
The Status window displays the following settings:
SecureSync 2400 User Manual 549
APPENDIX
To Next Page
Loading...
