To Next Page

To Previous Page

SINAMICS G120 Control Units CU240B-2/CU240E-2

List Manual (LH11), 01/2016, A5E33839529

253

2 Parameters

2.2 List of parameters

Description: Sets the proportional gain for the Lh adaptation of the motor model for an induction motor (ASM).

Dependency: Not visible with application class: "Standard Drive Control" (SDC, p0096 = 1), "Dynamic Drive Control" (DDC, p0096

= 2)

Description: Sets the integral time for the Lh adaptation of the motor model for an induction motor (ASM).

Dependency: Not visible with application class: "Standard Drive Control" (SDC, p0096 = 1), "Dynamic Drive Control" (DDC, p0096

= 2)

Description: Displays the corrective value for the Lh adaptation of the motor model for an induction motor (ASM).

Dependency: Not visible with application class: "Standard Drive Control" (SDC, p0096 = 1), "Dynamic Drive Control" (DDC, p0096

= 2)

Refer to: p0826, p1780

Note: The adaptation result is reset if the magnetizing inductance of the induction motor is changed (p0360, r0382). This

also happens when changing over the data set if a different motor is not being used (p0826).

The display of the inactive data sets is only updated when changing over the data set.

Description: Displays the switch-on stator frequency/ primary section frequency for the Lh adaptation for the induction motor

(ASM).

Dependency: Not visible with application class: "Standard Drive Control" (SDC, p0096 = 1), "Dynamic Drive Control" (DDC, p0096

= 2)

Description: Displays the switch-on slip frequency for the Lh adaptation for the induction motor (ASM).

p1785[0...n] Motor model Lh adaptation Kp / MotMod Lh Kp

Access level: 4 Calculated: p0340 = 1,3,4 Data type: FloatingPoint32

Can be changed: U, T Scaling: - Dyn. index: DDS, p0180