To Next Page

To Previous Page

2 Parameters

2.2 List of parameters

SINAMICS G120 Control Units CU240B-2/CU240E-2

482 List Manual (LH11), 01/2016, A5E33839529

Description: Display parameter for output quantity Y of instance AVA 0 of the absolute value generator with sign evaluation.

Description: Display parameter for signal SN that the input quantity X of instance AVA 0 of the absolute value generator with sign

evaluation is negative.

X < 0.0 => SN = 1

Description: Setting parameter for the run-time group in which instance AVA 0 of the absolute value generator with sign

evaluation is to be called.

Value: 5: Run-time group 5

6: Run-time group 6

9999: Do not calculate

Description: Setting parameter for the run sequence of instance AVA 0 within the run-time group set in p20131.

Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run

sequence value.

Description: Sets the signal source of the input quantity X of instance AVA 1 of the absolute value generator with sign evaluation.

r20129 CO: AVA 0 output Y / AVA 0 output Y

Access level: 3 Calculated: - Data type: FloatingPoint32

Can be changed: - Scaling: PERCENT Dyn. index: -