To Next Page

To Previous Page

2 Parameters

2.2 List of parameters

SINAMICS G120 Control Units CU240B-2/CU240E-2

472 List Manual (LH11), 01/2016, A5E33839529

Description: Display parameter for the inverted output of instance NOT 0 of the inverter.

Description: Setting parameter for the run-time group in which the instance NOT 0 of the inverter is to be called.

Value: 1: Run-time group 1

2: Run-time group 2

3: Run-time group 3

4: Run-time group 4

5: Run-time group 5

6: Run-time group 6

9999: Do not calculate

Description: Setting parameter for the run sequence of instance NOT 0 within the run-time group set in p20080.

Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run

sequence value.

Description: Sets the signal source of input quantity I of instance NOT 1 of the inverter.

Description: Display parameter for the inverted output of instance NOT 1 of the inverter.

r20079 BO: NOT 0 inverted output / NOT 0 inv output

Access level: 3 Calculated: - Data type: Unsigned32

Can be changed: - Scaling: - Dyn. index: -