SINAMICS G120 Control Units CU240B-2/CU240E-2
List Manual (LH11), 01/2016, A5E33839529
89
2 Parameters
2.2 List of parameters
Description: Maximum permissible input speed at the load gearbox.
The following applies when calculating the maximum speed (p1082):
- for p0324 = 0 or p0532 = 0 or p0542 = 0, p0322 is used.
- for p0324 > 0, p0532 > 0 and p0542 > 0, the minimum value from the parameters is used.
Description: Maximum permissible input torque at the load gearbox.
Description: Sets the numerator for the overall ratio of the load gearbox.
Description: Sets the denominator for the overall ratio of the load gearbox.
Description: Sets the inversion for the direction of rotation of the load gearbox.
Description: Sets the brake version.
p0542[0...n] Load gearbox maximum speed / Load grbx n_max
Access level: 3 Calculated: - Data type: FloatingPoint32
Can be changed: T Scaling: - Dyn. index: MDS
Unit group: - Unit selection: - Func. diagram: -
Min Max Factory setting
0 [rpm] 340.28235E36 [rpm] 0 [rpm]
p0543[0...n] Load gearbox maximum torque / Load grbx M_max
Access level: 3 Calculated: - Data type: FloatingPoint32
Can be changed: T Scaling: - Dyn. index: MDS
Unit group: 7_1 Unit selection: p0505 Func. diagram: -
Min Max Factory setting
0 [Nm] 340.28235E36 [Nm] 0 [Nm]
p0544[0...n] Load gearbox overall ratio (absolute value) numerator / Load grbx ratio N
Access level: 3 Calculated: - Data type: Integer32
Can be changed: T Scaling: - Dyn. index: MDS
Unit group: - Unit selection: - Func. diagram: -
Min Max Factory setting
0 2147483647 0
p0545[0...n] Load gearbox overall ratio (absolute value) denominator / Load grbx ratio D
Access level: 3 Calculated: - Data type: Integer32
Can be changed: T Scaling: - Dyn. index: MDS
Unit group: - Unit selection: - Func. diagram: -
Min Max Factory setting
0 2147483647 0
p0546[0...n] Load gearbox output direction of rotation inversion / Load grbx outp inv
Access level: 3 Calculated: - Data type: Integer32
Can be changed: T Scaling: - Dyn. index: MDS
Unit group: - Unit selection: - Func. diagram: -
Min Max Factory setting
0 2147483647 0
p0550[0...n] Brake type / Brake type
Access level: 3 Calculated: - Data type: Unsigned16
Can be changed: T Scaling: - Dyn. index: MDS
Unit group: - Unit selection: - Func. diagram: -
Min Max Factory setting
0 65535 0
To Next Page
Loading...
Need help?
General