To Next Page

To Previous Page

SINAMICS G120 Control Units CU240B-2/CU240E-2

List Manual (LH11), 01/2016, A5E33839529

491

2 Parameters

2.2 List of parameters

Index: [0] = Input pulse I

[1] = Reset input R

Description: Setting parameter for pulse duration T in milliseconds of instance PST 0 of the pulse extension element.

Description: Display parameter for output pulse Q of instance PST 0 of the pulse extension element.

Description: Setting parameter for the run-time group in which the instance PST 0 of the pulse extension element is to be called.

Value: 5: Run-time group 5

6: Run-time group 6

9999: Do not calculate

Description: Setting parameter for the run sequence of instance PST 0 within the run-time group set in p20181.

Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run

sequence value.

Description: Sets the signal source for input pulse I and the reset input R of instance PST 1 of the pulse extension element.

Index: [0] = Input pulse I

[1] = Reset input R

p20179 PST 0 pulse duration in ms / PST 0 pulse_dur ms

Access level: 3 Calculated: - Data type: FloatingPoint32

Can be changed: T Scaling: - Dyn. index: -