To Next Page

To Previous Page

2 Parameters

2.2 List of parameters

SINAMICS G120 Control Units CU240B-2/CU240E-2

512 List Manual (LH11), 01/2016, A5E33839529

Description: Setting parameter for the run-time group in which the instance NOT 4 of the inverter is to be called.

Value: 1: Run-time group 1

2: Run-time group 2

3: Run-time group 3

4: Run-time group 4

5: Run-time group 5

6: Run-time group 6

9999: Do not calculate

Description: Setting parameter for the run sequence of instance NOT 4 within the run-time group set in p20302.

Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run

sequence value.

Description: Sets the signal source of input quantity I of instance NOT 5 of the inverter.

Description: Display parameter for the inverted output of instance NOT 5 of the inverter.

Description: Setting parameter for the run-time group in which the instance NOT 5 of the inverter is to be called.

Value: 1: Run-time group 1

2: Run-time group 2

3: Run-time group 3

4: Run-time group 4

5: Run-time group 5

p20302 NOT 4 run-time group / NOT 4 RTG

Access level: 3 Calculated: - Data type: Integer16

Can be changed: T Scaling: - Dyn. index: -