To Next Page

To Previous Page

2 Parameters

2.2 List of parameters

SINAMICS G120 Control Units CU240B-2/CU240E-2

494 List Manual (LH11), 01/2016, A5E33839529

Description: Display parameter for output Q of instance RSR 1 of the RS flipflop

Description: Display parameter for inverted output QN of instance RSR 1 of the RS flipflop.

Description: Setting parameter for the run-time group in which instance RSR 1 of the RS flipflop is to be called.

Value: 1: Run-time group 1

2: Run-time group 2

3: Run-time group 3

4: Run-time group 4

5: Run-time group 5

6: Run-time group 6

9999: Do not calculate

Description: Setting parameter for the run sequence of instance RSR 1 within the run-time group set in p20196.

Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run

sequence value.

Description: Sets the signal source for trigger input I, D input D, set input S, and reset input R of instance DFR 0 of the D flipflop.

Index: [0] = Trigger input I

[1] = D input D

[2] = Set S

[3] = Reset R

r20194 BO: RSR 1 output Q / RSR 1 output Q

Access level: 3 Calculated: - Data type: Unsigned32

Can be changed: - Scaling: - Dyn. index: -