To Next Page

To Previous Page

2 Parameters

2.2 List of parameters

SINAMICS G120 Control Units CU240B-2/CU240E-2

522 List Manual (LH11), 01/2016, A5E33839529

Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run

sequence value.

Description: Sets the signal source for the input pulse I of instance MFP 2 of the pulse generator.

Description: Setting parameter for pulse duration T in milliseconds of instance MFP 2 of the pulse generator.

Description: Display parameter for output pulse Q of instance MFP 2 of the pulse generator.

Description: Setting parameter for the run-time group in which the instance MFP 2 of the pulse generator is to be called.

Value: 5: Run-time group 5

6: Run-time group 6

9999: Do not calculate

Description: Setting parameter for the run sequence of instance MFP 2 within the run-time group set in p20357.

Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run

sequence value.

p20354 BI: MFP 2 input pulse I / MFP 2 inp_pulse I

Access level: 3 Calculated: - Data type: U32 / Binary

Can be changed: T Scaling: - Dyn. index: -