Setting up the machine
2.7 Work offsets
Milling
Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
105
2.7.5 Displaying the zero offset details.
For each work offset, you can display and edit all data for all axes. You can also delete work
offsets.
For every axis, values for the following data will be displayed:
● Coarse and fine offsets
● Rotation
● Scaling
● Mirroring
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Note
Settings for rotation, scaling and mirroring are specified here and can only be changed here.
Procedure
1. Select the "Parameter" operating area.
2. Press the "Work offset" softkey.
3. Press the "Active", "Base" or "G54…G599" softkey.
The corresponding window appears.
4. Place the cursor on the desired work offset to view its details.
5. Press the "Details" softkey.
A window opens, depending on the selected work offset, e.g. "Work
Offset - Details: G54 to G599".
6. You can edit the values directly in the table.
- OR -
Press the "Clear offset" softkey to reset all entered values.
To Next Page
Loading...
Need help?
General
