Siemens SINUMERIK 840D

Setting up the machine
2.11 MDA
Milling
Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
115
2.11.3 Executing an MDA program
Proceed as follows
1. Select the "Machine" operating area.
2. Press the <MDA> key.
The MDA editor opens.
3. Input the desired G-code commands using the operator’s keyboard.
4. Press the <CYCLE START> key.
The control executes the input blocks.
When executing the G-code commands, you can control the sequence as follows:
● Executing the program block-by-block
● Testing the program
Settings under program control
● Setting the test-run feedrate
Settings under program control