Alarms, error messages, and system alarms
20.6 Logbook
Milling
590 Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
20.6 Logbook
The logbook provides you with the machine history in an electronic form.
If service is carried out on the machine, this can be electronically saved. This means that it is
possible to obtain a picture about the "History" of the control and to optimize service.
Editing the logbook
You can edit the following information:
● Editing information on the machine identity
– Machine name/No.
– Machine type
– Address data
● Make logbook entries (e.g. "filter replaced")
Output of the logbook
You have the possibility of exporting the logbook by generating a file using the "Save
version" function in which the logbook is contained as section.
20.6.1 Displaying and editing the logbook
Procedure
1. Select the "Diagnostics" operating area.
2. Press the "Version" softkey.
3. Press the "Logbook" softkey.
The "Machine logbook" window opens.
Editing end customer data
You have the option of changing the address data of the end
customer using the "Change" softkey.
To Next Page
Loading...
Need help?
General
