Siemens SINUMERIK 840D

Ladder Viewer and Ladder add-on (828D only)
19.17 Displaying the network symbol information table
Milling
576 Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
Further search options
1. Press the "Go to start" softkey to jump to the start of the ladder
diagram in window 1 or window 2, or the list (cross references, symbol
table).
2. Press the "Go to end" softkey to jump to the end of the ladder diagram
in window 1 or window 2, or the list (cross references, symbol table).
19.17 Displaying the network symbol information table
All of the symbolic identifiers used in the selected network are displayed in the "Network
symbol information table" window.
The following information is listed:
● Names
● Absolute addresses
● Comments
The symbol information table remains empty for networks that do not contain any global
symbols.
Procedure
1. The ladder diagram display (LAD) is opened.
2. Select the desired network and press the "Symbol info" softkey.
The "Network Symbol Information Table" window appears.
3. Use the cursor keys to move within the table.